Forum
=> Not registered yet?You can enter queries here.
Forum - Connection settings for PC - Mobile
| You are here: Forum => FBUS Tutorial => Connection settings for PC - Mobile |
|
| abicash (24 posts so far) |
If ur cable also uses MBUS pin then it is a dual cable which supports both FBUS and MBUS This cable can be used as it is to PC side But when u r connecting it to microcontroller u have to convert the RS232 signals to TTL so u will need to put a MAX232 in betwn cable and Micro.Also u will need to connect DTR to +12V and RTS to -12V (which u can find on MAX232) But u can avoid all this by cutting the DB9 header female and put ur own female with no electronics. With this scheme u CANNOT connect to PC but u can connect to micro and avoid the DTR and RTS connection which is what I have done. So now u can put a MAX232 anyway on ur board for sniffing comm betwn micro and phone,becos both r on TTL (remembr the 5v to 3v though) the PC is just a watch terminal now. u can write a small progrm to send 55hex 128 times to phone followed by get version frame. and see what phone responds. check the tutorial again | |||
| chakra (Gast) |
Hi Abicash, Should i cut the DB9 female from the cable and connect it with new DB9 Female? But i contains some electronis for level conversion right! could you give a clear explanation please... | |||
| chakra (Gast) |
Abicash I am Clear about whatever you are saying but now i want to check connecting my mobile with the hyperterminal. for that what i should do since iam not getting any output from hyperterminal. I would like to clear with this first. Are you getting me. I want to connect my Nokia 3310 Mobile to the Hypertermianl and try sending SMS and Receiving SMS through Hyperterminal. Please help me out.../. If you dont mind give your contact i will clear my doubt tharough Phone.... Thank you.... | |||
| chakra (Gast) |
Hi Abicash i am waiting for your reply.. Sorry if i am putting more questions on you and disturbing.. Please clear me this.. | |||
| abicash (24 posts so far) |
you cannot do that on hyperterm because u need to send some special hex codes like 1Ehex which doesnt have equivalent ASCII value(so u cannot enter via keyboard) u can enter '0'(zero) via keybord which is ASCII 0x30 (30hex)..so u see its highly impossible to send a train of codes which do not have ASCII equivalent,unless of course u send the whole frame which is highly improbable. Instead do the thing i mentioned previously Or use some simulation s/w like proteus which has a virtual terminal window |
Total topics: 14
Total posts: 87
Total users: 188
Online now (registered users): Nobody
